2026 cost guide · Akron, OH
Sump Pump Installation Cost in Akron, OH (2026 Prices)
Most sump pump jobs in Akron cost about $400 to $2,500. Swapping a worn-out pump in an existing pit is the cheap end, usually $400 to $900. Cutting a new pit into the basement floor and installing a pump, check valve and discharge line usually runs $1,100 to $2,500. A battery backup adds about $500 to $2,000.
Below: what each job costs, what changes the price in Akron, and how to tell if a pump alone will fix your basement or if you need more.
- Akron and national ranges from 2026 data
- What’s included at each price
- When a pump isn’t enough
Price by job
How Much Does Each Type of Sump Pump Job Cost?
These are installed prices, parts and labor, for a typical Akron basement. Your quote can land higher if the pit is hard to reach, the discharge line has a long run, or finished walls and floors are in the way.
| Job | Typical installed cost | What’s included |
|---|---|---|
| Replace a pump in an existing pit | $400 to $900 | New pump, check valve if worn, test run |
| New pit and pump, no drain tile | $1,100 to $2,500 | Cut floor, dig and set basin, pump, check valve, discharge line |
| Pedestal pump installed | $800 to $1,500 | Motor sits above the pit; cheaper but louder |
| Submersible pump installed | $1,200 to $3,000 | Sealed pump sits in the pit; quieter, usual choice for Akron basements |
| Battery backup added | $500 to $2,000 | Second pump, battery, charger and alarm |
| Water-powered backup added | $1,200 to $2,500 | Runs on city water pressure, no battery to replace |
| Interior drain tile with sump pump | $3,000 to $9,000 | Perimeter drain under the floor edge routed to the pit |
Ranges combine national 2026 installed-cost data with published Akron pricing. They’re typical ranges, not quotes. For full drain systems, see the Akron basement waterproofing cost guide.
Price factors
What Makes a Sump Pump Cost More or Less in Akron?
01
Is there already a pit?
Replacing a pump in a good pit is a short visit. Cutting through a concrete floor, digging and setting a new basin is most of the cost of a new install.
02
Pump type and size
A 1/3 HP submersible handles most Akron homes. A bigger pump, or a cast-iron model, costs more but is only worth it if water comes in fast.
03
Where the water can go
Akron and the Ohio EPA don’t allow sump water in the sanitary sewer. A long or buried discharge line to a legal outlet adds labor and pipe.
04
Battery or water backup
Storms that fill the pit are often the same storms that cut the power. A backup pump adds equipment cost but protects a finished basement.
05
Access and finished space
Finished walls, flooring or a tight utility room near the pit can add time for cutting, protecting and patching.
06
Electrical and permits
A pump needs its own reliable outlet nearby. If new wiring or a permit is needed, that adds cost. Permit fees typically run about $50 to $250 where one is required.
Real-world examples
What Would Your Job Likely Cost? Three Common Akron Scenarios
01
The old pump quit
You already have a pit and drain tile, and the pump is 8 to 10 years old or stuck. A new submersible pump and check valve usually costs $400 to $900.
02
Water at the floor edge, no pit
Water seeps in where the wall meets the floor after heavy rain. A pump alone won’t collect that water. You likely need an interior drain routed to a new pit, usually $3,000 to $9,000 total.
03
Pump works, power doesn’t
Your pump is fine, but summer storms knock out power and the pit overflows. Adding a battery backup usually costs $500 to $2,000, depending on the unit.
Not sure which one sounds like your basement? Our sump pump installation guide explains sizing, discharge and backup options in plain English.
Before you sign
What Should a Sump Pump Quote Include?
- Pump brand, model and horsepower, and whether it’s submersible or pedestal
- Basin size, and whether it has a sealed, airtight lid
- A check valve on the discharge line
- Where the discharge line ends, and confirmation it does not go into the sanitary sewer
- Freeze protection for the outside part of the line
- Battery or water-powered backup, priced as a separate line
- Who handles any electrical work or permit
- Warranty on the pump and on the labor
If a quote just says “install sump pump” with one price, ask for these details in writing before you agree to it.
Save money
How to Lower Your Sump Pump Cost
- Test the pump first. Pour a bucket of water into the pit. If the float rises and the pump runs, the problem may be a stuck float or a clogged inlet, not a dead pump.
- Fix the outside water. Extend downspouts several feet from the house and slope soil away from the walls so the pump has less water to move.
- Replace before it fails. Swapping an aging pump on your schedule costs far less than an emergency call during a storm.
- Bundle the backup. Adding a battery backup during the same visit as a new pump usually saves a second trip charge.
Get a Written Price for Your Sump Pump
Book a free inspection or send a photo of your pit. We’ll tell you whether you need a new pump, a backup, or a drain system, and what it should cost, in writing.
FAQ
Sump Pump Cost Questions From Akron Homeowners
How much does it cost to install a sump pump in Akron?
Most jobs cost about $400 to $2,500. Replacing a pump in an existing pit is usually $400 to $900. A new pit and pump usually costs $1,100 to $2,500. A battery backup adds about $500 to $2,000.
How much does it cost to replace a sump pump?
If the pit and discharge line are in good shape, replacing the pump usually costs $400 to $900, including a new check valve when the old one is worn.
Is a battery backup sump pump worth it in Akron?
For a finished basement, usually yes. Heavy summer storms can fill the pit and cut power at the same time. A backup keeps pumping until the power comes back.
Can my sump pump drain into the sewer in Akron?
No. The City of Akron and the Ohio EPA prohibit storm water, including sump pump discharge, from going into the sanitary sewer. The line should run outside and away from your foundation.
Do I need a permit to install a sump pump in Akron?
It depends on the work. A simple pump swap often doesn’t need one, but new electrical work or drainage changes may. Ask your installer who pulls any permit, or check with the City of Akron building division.
How long does a sump pump last?
Many pumps last about 7 to 10 years. Pumps that run constantly, or sit in a pit full of debris, wear out sooner. Backup batteries usually need replacing every few years.
Will a sump pump alone stop my basement from leaking?
Only if the water reaches the pit. If water comes in along the floor edge or through cracks, you usually need a drain system or crack repair as well.